Mercedes Light Up Emblem Description:
【Applicable for Mercedes-Benz 】The appearance of this product is consistent with the original car standard, and it can be directly replaced by the original car standard. Its special vacuum plating technology not only ensures the same gloss as the original logo, but also ensures high transparency and uniform brightness.
【High Quality】 It adopts high-quality LED lamp set, featuring high brightness and long service life. It is specially designed to be waterproof and dustproof to ensure long-term use.
【Unique design】This product is specially designed for car modification enthusiasts. When the daytime car light is not bright, there is no difference with the original car standard. When the night license plate lighting is turned on, the LED car light will also light up, making the car Marked in the night to become dazzling, rich in future technology, highlighting the noble blood of your car.
【Easy Installation】 Use high-quality car special double-sided adhesive, strong and strong lasting!The LED light inside is specially waterproof and dustproof! LED lamps have a lifespan of up to 100,000 hours.
Mercedes Light Up Emblem Feature:
Diameter: 18.5 cm/7.28inch (Pls make sure your size dimension before ordering)
Wiring length: 0.6 meters
Material: ABS plating, 3M glue at the bottom
Package Contents:1* Mercedes Light Up Emblem Light
Avoid giving children a play. Do not accidentally install or disassemble this product during driving.
[Tools prepared before installation] Please have the following tools ready before you start:
1. Flat head screwdriver 2. Phillips screwdriver 3. Insulating tape 4. Towel 5. Pliers
【Mercedes Light Up Emblem Installation Notes】
1. First place a towel next to the logo, use a flat-blade screwdriver to shake the logo, and towel to prevent scratching the body.
2. Pay attention to peeling off the double-sided rubber first. When the squatting is moderate, don’t be too fierce.
After a little bit, slowly squat down, clean the car logo and the double-sided tape on the body.
3. Use a Phillips screwdriver to remove the partition inside the tail box. Note that there are clips in some places. Be careful to remove the baffles to see the various lines.
4. Now install the car standard light, the car standard light power line passes through one of the car standard positioning holes,
and wears the single-sided glue on the back of the car standard light inside the car box. While pulling the wire, the car mark light is glued to the vehicle body, and the pressure is pressed. tight.
5. The car light is installed, and now it is connected to the power supply. The car light should be connected to the power supply of the license plate, so that when the night light is turned on the car light will be turned on at the same time, and the power connector of the rear license plate light is found.
Not Enough for your car decor? Check this Mecedes Benz Tail Emblem Lights: https://www.carledlogo.com/car-logo-badge/mercedes-logo-badge-led-light/